DAAB EP102 User Manual
                          | |
Contents
| 
21Channel list for EP102The channel list is the same for control type EP102-1 (1 motor) and control type EP102-2 (2 motors).Certain channels apply only to control type EP102-2. These are marked by an * before the channelnumber.Measured value to be readNo. Specification RangeC00 Service channel, only for service personnel 000-999C01 Program version 0.00-9.99C02 Mains voltage, phase L1.(Accuracy of measurement +- 15%) 000-255 VC03 Voltage after stop circuit 00.0-30.0 VC04 Resistance, safety buffer close 1 (KSS1) 0.0-3.00 kΩC05 Resistance, safety buffer close 2 (KSS2) 0.0-3.00 kΩC06 Resistance, safety buffer open (KSÖ) 0.0-3.00 kΩC07 Load, motor 1 0.00-0.99 Cos ϕ*C08 Load, motor 2 0.00-0.99 Cos ϕC09 Motor current, motor 1 0.0-5.0 A*C10 Motor current, motor 2 0.0-5.0 AC11 Running time. motor 1 00-99 Sec*C12 Running time, motor 2 00-99 SecC13 Time motor 1 opened from closed positionUsed for limited opening00.0-59.9 SecC14 Number of openings (Total no of openings =C14+C15) 000-999 timesC15 Number of openings x1000 000-999 timesCommissioning: values to be entered when commissioningNo. Specification ValueRange Start SetC30 Limit for load sensor, motor 1 0.05-0.90 Cos ϕ 0.40*C31 Limit for load sensor, motor 2 0.05-0.90 Cos ϕ 0.40C32 Limited running time 05-99 Sec 10C33 Latched / deadman control0=Open and close, deadman control1=Open latched, close deadman control2=Open deadman control, close latched3=Open and close, latched0-3 0C34 Type of voltage feed. Used for the load sensor.0=3x400V+N, 1=3x230V, 2=1x230V0-2 0Delay of gate half, magnetic lockNo. Specification Value Start Set*C38 Time delay in opening motor 2 and closing motor 1.Used for magnetic lock or overlap of gate half0.1-5.00 sec 0.1C39 Time delay in opening before motor 1 starts, used formagnetic lock so that magnet can get rid of remmanence.0.00-0.99 sec 0.00 |
manualsdatabase
Your AI-powered manual search engine