DAELIM Roadwin R Service Manual

Contents

DAELIM Roadwin R Service Manual Manual pdf 248 page image

17-3BATTERY/CHARGING SYSTEMBATTERYREMOVAL/INSTALLATIONRemove the seat. ( 13-2)Remove the battery band.Disconnect the negative cable and then the positivecable and remove the battery.Install the battery in the reverse order of removal withthe proper wiring.VOLTAGE INSPECTIONMeasure the battery voltage using a multi tester.VOLTAGE:- Fully charged : 13.0~13.2V- Under charged : Below 12.3VTOOL : MULTI-TESTERBATTERY CHARGINGRemove the battery.Connect the charger positive (+) cable to the batterypositive (+) terminal.Connect the charger negative(-) cable to the batterynegative(-) terminal.Always turn the ignition switch to "OFF" beforeremoving the battery.Connect the positive terminal first and then thenegative cable.TERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALTERMINALBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERBATTERY HOLDERUse a voltmeter that will accurately indicate 0.1Vdifference.Never open the sealed filler cap.When measuring the battery voltage aftercharging, leave it for at least 30 minutes, or theaccurate results cannot be obtained because thebattery voltage fluctuates just after charging.Quick-charging should only be done in anemergency ; slow charging is preferred.For battery charging ; do not exceed the chargingcurrent and time specified on the battery. Usingexcessive current or extending the charging timemay damage the battery.