CM-4221 Installation Manual157.) If needed, connect the other end of the CAT5 cable to the network and turn on thepower from the power supply.Note: Do not reassemble the camera’s inner cover and mini-dome cover until afterhardware configurations and lens adjustments are made.4.6.2 Mounting the CM-4221-01, CM-4221-11, or CM-4221-11-I Outdoor Camera1.) Do one of the following: For drilled wall or ceiling mounting:a.) Use a pointed pencil and the base as a template to mark the mounting surfacethrough the plate holes where the four screw holes need to be drilled.Important: Before marking and drilling the holes, ensure that the base platealignment is oriented correctly so that the required camera field of view can beachieved when the system is assembled.b.) In the marked locations, drill each hole using a drill-bit of a slightly smallerdiameter than the supplied screw anchors (molly-plug anchor). You want toachieve a snug insertion so that the plug expansion holds firm after the screwsare screwed in.c.) Fully insert the supplied anchors into drilled holes. You may need to tap themflush with the wall using a finishing hammer. For installing on a 4S recessed electrical box:a.) Have a qualified installer (check your local electrical codes) rough-in the 4Srecessed electrical box and run the wires and power (if not PoE) through thewall/conduits to the box location.
