Camera Installation and Mounting72. Feed the Cat 5 Ethernet cable and video coax cable through the gland housing. The Ethernet cablegoes through the center of the gland housing. The analog video cable goes through one of the fiveouter holes of the gland housing.Figure 10: Installation Step 2 Illustration3. Push the gland housing over the cables.4. Push the gland rubber into the gland housing.Figure 11: Installation Step 4 Illustration5. Tighten the gland nut onto the gland housing. Leave about 3.15” (8cm) of cable sticking out of thegland housing.Figure 12: Installation Step 5 Illustration6. Insert the cables and gland housing into the camera and attach them to the connectors.Figure 13: Installation Step 6 Illustration7. Slide the gland housing chassis nut over the cables. Tighten the gland housing chassis nut into thecamera.Figure 14: Installation Step 7 Illustration8. Crimp the other end of the cables in place (not shown).
