Page 1-29seCTion 1 - ProduCT familiarizaTionUse Tapeto Pull MagneticMolding Awayfrom DoorPhillips ScrewdriverGrille PanelApproximate PositionFor ScrewsInstalling Backer PanelsRemove the door handle or trim piece on overlay models. A magnetic backed molding hides the handleor overlay trim screws. Use the adhesive side of the packaging tape on the magnetic backed moldingto pull it away from door (Fig. 8a). Remove the screws with a Phillips screwdriver (Fig. 8b). Slide thebacker panel into position. The backer panel needs to be under the trim. Install the handle. Replacethe molding in the channel, and reset the magnetic backed molding. To install the backer panel on thegrille remove the screws on the top and bottom of the upper cover (Fig. 8c). DO NOT REMOVE thefoam. Slide the backer panel into place and replace screws (Fig. 8d). If the thickness of the backerpanel is less than a ¼", back it up with a sheet of shim material to obtain a ¼" thickness. Cardboard isrecommended for Stainless Steel application. For panel size refer to Fig. 10.CAUTIONDo not drive screws or sharp objects into the doors. Do not pinch door seal when reinstalling handle.CAUTIONWhen attaching a raised wood panel of ½" orthicker, secure the raised panel to the backof the grille cover frame. Use 4 #8 or similarscrews. See illustration for approximatelocations.Fig. 8a Fig. 8bFig. 8c Fig. 8d
