Page 1-35seCTion 1 - ProduCT familiarizaTionAnchor the Unit (Optional)If you are attaching the unit to cabinetry, drill three 3/16" holes through bothouter trims. Drill 1/8" pilot holes into the cabinetry. Install screws.Additionally: If the depth/height of opening is excessive use steel hangerstrap. Double over strap at the anchor points to secure cabinet.Adjust Door HingesCheck to make sure the doors are properly adjusted. If not, adjust the tophinges. The hinges are slotted for side to side movement. Remove and discardthe small Phillips screw on the door hinge, which is located on the hinge. Adjustthe top hinges by loosing the 3 large Torx screws. Tighten the screws after thedoors are adjusted. Extruded door handles can be adjusted for alignment byloosening the screws under the magnetic backed molding (Fig. 8a).Drill 3 holes throughvertical frame intocabinetry. Whereapplicable. (approx.location)
