SETUP23Initial Setup1 Press [SETUP]. The Setup menu appears.While ‘Init Setup‘ is selected, press [ENTER] to go to the initial setuppage.2 Use [œ/√] to select ‘Preferences ‘.3 While ‘Preferences ‘ is selected, press [†] to select ‘Audio‘.4 Press [√]. The ‘Audio‘ submenu is displayed.Digital Output1 Use […/†] to select ‘Digital Output‘ while the Audio submenu isdisplayed.2 Press [√] to go to the second level.3 Use […/†] to select the desired digital output type.4 Press [ENTER] to confirm your selection.5 Press [SETUP] to exit the menu.OffNo signal will be output from the Digital Audio Out jacks.BitstreamSelect when connected to a Dolby Digital or DTS decoder (or an amplifier or other equipment with a DolbyDigital or DTS decoder).LPCMSelect when connected to a digital amplifier. The DVD Recorder+VCR's digital audio signal will be output in thePCM format when you play a DVD recorded with a Dolby Digital (only for DVD) or MPEG soundtrack. If the DVDis recorded with a DTS sound track then no sound will be heard.Dynamic RangeWhile watching DVD movies, you may wish to compress the dynamic rangeof the audio output (the difference between the loudest and quietestpassages). This allows you to listen to a movie at a lower volume withoutlosing clarity of sound.Set 'Dynamic Range'to anymode you want for this effect.Follow the same procedure as ‘Digital Output‘ to set the Dynamic Range.‘Preferences’ / Audio SettingsPreferencesVideo•Audio Digital Output BItstreamParental Ctrl Dynamic RangeAuto SettingsVCRModulator OutChoose OK ExitENTER SETUPœ √ …†PreferencesVideoAudio Digital OutputParental Ctrl Dynamic Range – – FULLAuto Settings – –VCR – – 1/2Modulator Out – –– – OFFChoose OK ExitENTER SETUPœ √ …†PreferencesVideoAudio • Digital Output OffParental Ctrl Dynamic Range BitstreamAuto Settings LPCMVCRModulator OutChoose OK ExitENTER SETUPœ √ …†DF-T35-37D2P-WB 2006.8.24 4:57 PM ˘ ` 23 mac001 1200DPI 90LPI