28Virtual SurroundYou can enjoy a simulated 3D effect from two speakers by setting VirtualSurround to On.Follow the same procedure as ‘Digital Output‘ to set the ‘VirtualSurround’ option.AudioDigital Output OffDynamic Range OffVirtual Surround OffInstructionsEnter-Confirm Setup-Exit Move …†Select VirtualSurroundOffOnFollow the same procedure as ‘Video’ Settings to select ‘Audio’ Settings.Digital Output1 Use […/†] to select ‘Digital Output‘ while the ‘Audio’ submenu isdisplayed.2 Press [ENTER] or [√] to go to the second level.3 Use […/†] to select the desired digital output type.4 Press [ENTER] to confirm your selection.5 Press [SETUP] to exit the menu.OffNo signal will be output from the Digital Audio Out jacks.LPCMSelect when connected to a 2 channel digital stereo amplifier. The DVDRecorder+VCR's digital audio signal will be output in the PCM 2ch formatwhen you play a DVD (or VHS tape) recorded with a Dolby Digital (only for DVD) or MPEG soundtrack. If the DVDis recorded with a DTS sound track then no sound will be heard.BitstreamSelect when connected to a Dolby Digital or DTS decoder (or an amplifier or other equipment with a DolbyDigital or DTS decoder).Initial SetupAudioDigital Output OffDynamic Range OffVirtual Surround OffInstructionsEnter-Confirm Setup-Exit Move …†Select DigitalOutputOffBitstreamLPCMPREFERENCES / Audio SettingsPreferencesVideoAudioParental ControlsAuto SettingsVCRInstructionsEnter-Confirm Setup-ExitMove …†Dynamic RangeWhile watching DVD movies, you may wish to compress the dynamicrange of the audio output (the difference between the loudest andquietest passages). This allows you to listen to a movie at a lowervolume without losing clarity of sound. Set ‘Dynamic Range‘ to Low orHigh for this effect.Follow the same procedure as ‘Digital Output‘ to set the ‘DynamicRange’.AudioDigital Output OffDynamic Range OffVirtual Surround OffInstructionsEnter-Confirm Setup-Exit Move …†Select DynamicRangeOffLowHigh