52TroubleshootingTroubleshootingCheck the following guide for the possible cause of a problem before contacting customer support.No power.No picture.No sound.Playback picture is poor.DVD Recorder+VCR doesnot start playback.Picture from external inputis distorted.Some channels are skippedover when using [PR+/–].Picture or sound ofbroadcasting channel isweak or missing.Camcorder image not shown.Camcorder image via A/Vinput to DVD Recorder+VCRis not shown on TV screen.The power cord is disconnected.The TV is not set to receive DVDRecorder+VCR signal output.The video cable is not connectedsecurely.The TV power is turned off.The equipment connected with theaudio cable is not set to receiveDVD Recorder+VCR signal output.The audio cables are not connectedsecurely.The power on the equipmentconnected with the audio cable isturned off.The audio cables are damaged.The disc is dirty.Tape heads are dirty.Tape is a rental or was recorded onanother VCR.No disc is inserted. No tape isinserted.An unplayable disc is inserted.The disc is placed upside down.The disc is not placed within theguide.The disc is dirty.The Parental Control level is set.The video signal from the externalcomponent is copy-protected.The skipped channels were deletedwith the ‘Adjust Channels’ menu.Antenna or cables are loose.Wrong Tuning Band is selected inthe DVD Recorder+VCR Setup menu.Camcorder is off.DVD Recorder+VCR’s source is notset to AV1, AVF or DV.Plug the power cord into the wall outletsecurely.Select the appropriate video input on theTV so the picture from the DVDRecorder+VCR appears on the TV screen.Connect the video cable securely.Turn on the TV.Select the correct input mode on theaudio receiver so you can listen to thesound from the DVD Recorder+VCR.Connect the audio cables securely.Turn on the equipment connected withthe audio cable.Replace with new ones.Clean the disc.Clean the video heads.Use [Tracking +/–] for manual trackingadjustment while a tape is playing.Insert a disc or tape. (Check that the discindicator on the front panel display is lit.)Insert a playable disc. (Check the disctype, colour system, and regional code.)Place the disc with the playback side down.Place the disc on the disc tray correctlyinside the guide.Clean the disc.Cancel the Parental Control function orchange the rating level.You cannot connect via the DVDRecorder+VCR. Connect the componentdirectly to your TV.Use the ‘Adjust Channels’ menu torestore channels.Tighten connections or replace cable.Try all ‘Auto Scan‘ options; see page 18for details.Turn camcorder on and operate properly.Use [INPUT] to select AV input channel(AV1, AVF or DV).SymptomCauseSolutionDF-Q75D2D-HS-4(GB) 2006.6.2 10:7 AM ˘ ` 52 mac001 1200DPI 90LPI