189Parameter FunctionLatch The alarm output can delay for the specified time after an alarm stops.The value ranges from 1s to 300s.ShowmessageSystem can pop up a message to alarm you in the local host screen ifyou enabled this function.AlarmuploadSystem can upload the alarm signal to the centre (Including alarmcentre.SendEmailIf you enabled this function, System can send out an email to alert youwhen an alarm occurs.Buzzer Check the box here to enable this function. The buzzer beeps when analarm occurs.5.8.3.4 Alarm OutputIt is to set alarm output mode. See Figure 5-64.Figure 5-645.8.4 Storage5.8.4.1 Schedule5.8.4.1.1 Schedule RecordIn this interfaces, you can add or remove the schedule record setup. See Figure 5-65.There are three record modes: general (auto), motion detect and alarm. There are sixperiods in one day.You can view the current time period setup from the color bar. Green color stands for the general record/snapshot.
