Daikin CTXA15A2V1BW Operation Manual

Also see for CTXA15A2V1BS: Installer's reference guide Installation manual Service manual Installation manual User reference guide

Contents

Daikin CTXA15A2V1BW Operation Manual Manual pdf 7 page image

4 OperationOperation manual7(C)(F)TXA15~50A2V1B(W)(S)(T)Daikin room air conditioner3P485919-7C – 2017.12▪ Defrost operation. During heating operation, frost might occur onthe outdoor unit and decrease the heating capacity. In that case,the system automatically switches to defrosting operation toremove the frost. During defrosting operation, hot air is NOTblown from the indoor unit.▪ Humidity sensor. Control the humidity by decreasing thehumidity during cooling process.4.3.1 To start/stop operation and to set thetemperature: Unit is operating.: Operation mode = Automatic: Operation mode = Drying: Operation mode = Cooling: Operation mode = Heating: Operation mode = Fan only: Shows the set temperature.1 Press one or more times to select the operation mode.Result: The mode will be set as follows:2 Press to start operation.Result: and the selected mode are displayed on the LCD.3 Press or one or more times to lower or raise thetemperature.CoolingoperationHeatingoperationAutomaticoperationDrying or Fanonly operation18~32°C 10~30°C 18~30°C —Note: When using drying or fan only mode, you cannot adjust thetemperature.4 Press to stop operation.Result: disappears from the LCD. The operation lamp goesoff.4.3.2 Airflow rateNote: If the unit reach the temperature set point in cooling, heatingor automatic mode. Fan will stop operating.1 Press to choose:5 airflow rate levels, from " " to " "Automatic operationIndoor unit quiet operation. When the airflow is set to" ", the noise from the unit will be reduced.Note: When using drying operation mode, you CANNOT adjust theairflow rate setting.To adjust the airflow rate1 Press to change the airflow setting as follows:4.3.3 Airflow directionWhen. Adjust the airflow direction as desired.What. The system directs the airflow differently, depending on theuser selection (swinging or fixed position). It does so by movinghorizontal blades (flaps) or vertical blades (louvers).Setting Airflow directionVertical automaticswingMoves up and down.Horizontalautomatic swingMoves from side to side.+ 3-D airflowdirectionMoves simultaneously up and down andfrom side to side[—] Stays in a fixed position.CAUTION▪ ALWAYS use a user interface to adjust the position ofthe flaps and louvers. When the flaps and louvers areswinging and you move them forcibly by hand, themechanism will break.▪ Be careful when adjusting the flaps and louvers. Insidethe air outlet, a fan is rotating at high speed.Note: The movable range of the flap varies according to theoperation mode. The flap will stop at the upper position when theairflow rate is changed to low during the up and down swing setting.aba Flap range in cooling or drying operationb Flap range in heating or fan only operationTo adjust vertical airflow direction1 Press .Result: appears on the LCD. The flaps (horizontal blades)will begin to swing.2 To use fixed position, press when the flaps reach thedesired position.Result: disappears from the LCD. The flaps will stopmoving.To adjust horizontal airflow direction1 Press .Result: appears on the LCD. The louvers (verticalblades) will begin to swing.2 To use fixed position, press when the louvers reach thedesired position.Result: disappears from the LCD. The flaps will stopmoving.To use 3-D airflow direction1 Press and .Result: and appear on the LCD. The flaps (horizontalblades) and louvers (vertical blades) will begin to swing.