Instruction SiUS12-81492 Operation Manual2.13 Care and CleaningCTXS09/12GVJU gCAUTIONTo avoid possible bodily injury, units should be shutoff or disconnected before any cleaning or servicing is attempted. Indoor unit, Outdoor unit and Remote controller1. Wipe them with dry soft cloth. Front panel1. Open the front panel.• Hold the panel by the tabs on the two sides andlift it until it stops with a click.2. Remove the front panel.• Open the front panel further while sliding it toeither the left or right and pulling it toward you.This will disconnect the rotation dowel on oneside. T hen disconnect the rotation dowel on theother side in the same manner.3. Clean the front panel.• Wipe it with a soft cloth soaked in water.• Only neutral detergent may be used.• In case of washing the panel with water, dry it with cloth, dry it up in the shade after washing.4. Attach the front panel.• Align the rotation dowels on the left and right of the front panel withthe slots, then push them all the way in.• Close the front panel slowly. (Press the panel at both sides and thecenter.)CAUTIONUnits• When the packaging materials are attached to the front panel,please remove them.• Don’t touch the metal parts of the indoor unit. If you touch thoseparts, this may cause an injury.• When removing or attaching the front panel, use a robust and stablestool and watch your steps carefully.• When removing or attaching the front panel, support the panelsecurely with hand to prevent it from falling.• For cleaning, do not use hot water above 104 °F, benzine, gasoline,thinner, nor other volatile oils, polishing compound, scrubbingbrushes, nor other hand stuff.• After cleaning, make sure that the front panel is securely fixed.Before cleaning, be sure to stop the operation andturn the breaker OFF.
