SiBE12-908 Operation ManualInstallation / Operation Manual 803. Operation Manual3.1 Names of PartsName of Parts Indoor Unit1.Air filter2.Titanium apatite photocatalyticair-purifying filter:• These filters are attached to the inside of the airfilters.3.Air inlet4.Front panel5.Panel tab6.Room temperature and humiditysensors:• It senses the air temperature and humidity aroundthe unit.7.INTELLIGENT EYE sensor: (page 15.)8.Control panel9.Air outlet10.Flaps (horizontal blades): (page 10.)11.Louvers (vertical blades):• The louvers are inside of the air outlet. (page 10.)12.Air supply filter (gray)13.Indoor Unit ON/OFF switch: (page 8.)• Push this switch once to start operation.Push once again to stop it.• The operation mode refers to the following table.• This switch is useful when the remote controller ismissing.14.Multi-monitor lamp: (page 8.)• The lamp color changes according to theoperation.• AUTO............................................. Blue/Red• DRY ...............................................Green• COOL.............................................Blue• HEAT .............................................Red• FAN................................................White15.TIMER lamp (yellow): (page 19.)16.INTELLIGENT EYE lamp (green): (page 15.)17.Signal receiver:• It receives signals from the remote controller.• When the unit receives a signal, you will hear ashort beep.• Operation start...............................beep-beep• Settings changed ......................... beep• Operation stop ............................. beeeeep Outdoor Unit18.Air inlet: (Back and side)19.Refrigerant piping, humidifying hose andinter-unit cables20.Drain hoses21.Earth terminals:• It is inside of this cover.22.Air outlet23.Humidifying hoses24.Humidity unit17 151613192320211 3 457911108218242261214Indoor UnitOutdoor UnitMode Temperature setting Airflow rateAUTO 25°C AUTO4
