Wireless Remote Controller SiME281501E15 Remote Controller2.3 Address and MAIN/SUB SettingIntroductionTo set the wireless remote controller, you have to set the address for: The receiver of the wireless remote controller The wireless remote controller.Setting the Address for the ReceiverThe address for the receiver of the wireless remote controller is factory setting to 1. To change this setting,proceed as follows:Set the wireless address switch (SS2) on the PCB according to the table below.When using both a wired and a wireless remote controller for 1 indoor unit, the wired controller should be setto MAIN. Therefore, set the MAIN/SUB switch (SS1) of the receiver to SUB.For FCQ, FBQSetting the Address for the Wireless Remote ControllerThe address for the wireless remote controller is factory setting to 1. To change this setting, proceed asfollows:1. Hold down the “ ” button and the “ ”button for at least 4 seconds to get the Field Setting mode.(Indicated in the display area in the figure at right.)2. Press the “ ” button and select a multiple setting(A/b). Each time the button is pressed the displayswitches between “A” and “b”.3. Press the “ ” button or “ ” button to set the address.Address can be set from 1 to 6, but set it to 1 ~ 3 and tosame address as the receiver. (The receiver does notwork with address 4 ~ 6.)4. Press the “ ” button to enter the setting.5. Hold down the “ ” button for at least 1 second toquit the Field Setting mode and return to the normaldisplay.Unit No. No. 1 No. 2 No. 3Wireless addressswitch (SS2)MAIN/SUB MAIN SUBMAIN/SUBswitch (SS1)1 2 31 2 31 2 3SMSMModeAddressMultiplesetting32415/TESTFANUP DOWN1 2 3 4 5 6RESERVE/TEST
