ENGLISHCONTROLS PROCEDURE Press the key 6, SET CLOCK will appear. Press key 2 several times until "USER" is displayed Press key 6. "SET THERMOSTAT" will appear Press key 2 until "PELLET" is displayed. Use key 4 to increase and 5 to decrease the load during the WORKphase. Press key 6 to confirm and 1 to return to the previous menusback to the initial status.NO FUEL: the stove can never develop a suitable flame, tending to remain very low even at high powers. at minimum power the stove tends to almost switch-off taking the stove into “NO PELLETS” alarm condition. when the stove displays the “NO PELLETS” alarm, there may be non-burned pellets inside the burn pot.EXCESS FUEL: the stove develops a very high flame even at low power. the panoramic glass is very dirty, obscuring it almost totally. the burn pot tends to become encrusted, blocking the holes for air intake due to the excessive pellet feed, as it is onlyburned partially.The regulation to be performed is a percentage. Therefore a modification of this parameter will lead to a proportionalvariation of all stove feeding speeds. Feeding is from -30% to +20%.Follow the procedure on the display to perform this adjustment:STAND-BYThe Stby function is used if immediate stove switch-off or modulation via additional external thermostat is desired.CONTROLS PROCEDURE Press the key 6, SET CLOCK will appear. Press key 2 several times until "USER" is displayed Press key 6. "SET THERMOSTAT" will appear Press key 2 until "STAND BY" is displayed. Use keys 4-5 to enable/disable. Press key 6 to confirm and 1 to return to the menuback to the initial status.V1-FANThis menu allows (in models where provided) adjusting the front fan speed percentage.CONTROLS PROCEDURE Press the key 6, SET CLOCK will appear. Press key 2 several times until "USER" is displayed Press key 6. "SET THERMOSTAT" will appear Press key 2 until "V1 FAN" is displayed. Use keys 4 to increase and 5 to decrease Press key 6 to confirm and 1 to return to the menuback to the initial status.166
