ENGLISHCHRONOThe chrono allows to program 4 time spans within a day to use every day of the week.The switch-on and switch-off time can be set in every time span. along with thedays of use of the programmed time span and the desired H2O temperature (65- 80°C).RECOMMENDATIONSThe ignition and switch-off times must be within the arc ofone day, from 0 to 24 and not over several days:Before using the chrono function, set the current day andtime. Therefore check that the points listed in the “Set clock”sub-chapter have been followed, so that the chrono functionworks. Aside from programming it, activate it as well.Example:Switch-on time 07:00 CORRECTSwitch-off time 18:00Switch-on time 22:00 INCORRECTSwitch-off time 05:00RESETAllows to reset all values modifiable by the user to the default values. The modified data are:CONTROLS PROCEDURE Press the key 6, SET CLOCK will appear. Press key 2 several times until "USER" is displayed Press key 6. "SET THERMOSTAT" will appear Press key 2 until "RESET" is displayed. Use keys 4-5 to select ON and press key 6. The word " DONE" will be displayed to confirm SET H2O = 75°C SET TEMPERATURE = 35°C SET POWER = 5 ENABLE CHRONO = OFF START PRG1=OFF STOP PRG1 = OFF MONDAY PRG1 = OFF .......all chrono parameters OFF PELLET = 00% STAND BY = OFFKEYS LOCKEDThe menu allows to lock the display keys (like mobile phone). Press keys 1 and 5 simultaneously.With the function activated, “KEYS LOCKED” will appear every time a key is pressed.CONTROLS PROCEDURE Press the key 6, SET CLOCK will appear. Press key 2 several times until "USER" is displayed Press key 6. "SET THERMOSTAT" will appear Press key 2 until "KEYS LOCKED" is displayed. Use keys 4-5 to enable/disable. Press key 6 to confirm and 1 to return to the menuback to the initial status.AIR DISCHARGEThis function allows venting any air in the stove. Upon activating the function: The indicator lights of the circulators will light up on the display.(the pumps will be powered for 15 minutes and 30 seconds and then will stop for 30 seconds; cut the power to interrupt)CONTROLS PROCEDURE Press keys 1 and 4 simultaneously. You will be prompted to enter the password. Enter code "77", using key 4 Confirm using key 6.67
