Falcon 4M Camera Manual03-032-20044-01 DALSA22gpc get prnu coefficient xy 1-2352:1-1728gsf get signal frequency m 1/4/h helplpc load pixel coefficientrc reset camerarfs restore factory settingsrpc reset pixel coefficientsrus restore user settingssao set analog offset ti 0-0:0-511sbr set baud rate m 9600/19200/57600/115200/sdo set digital offset ti 0-2:0-2048sem set exposure mode m 2/3/4/6/7/set set exposure time f 492-999989 [us]sfc set fpn coefficient xyi 1-2352:1-1728:0-1023snd set number frame dumps i 1-7sot set output throughput m 260/320/spc set prnu coefficient xyi 1-2352:1-1728:0-12287ssb set subtract background ti 0-2:0-511ssf set sync frequency f 1.0-60.4 [Hz]ssg set system gain ti 0-2:0-65535svm set video mode i 0-12vt verify temperaturevv verify voltageswfc write fpn coefficientswpc write prnu coefficientswse window start end iixyxy 0-0:1-1:1-1:1-1725:2352-2352:4-1728wss window set sequence i 0-1wts window trigger source m 1/2/wus write user settingsOK>Retrieving Camera SettingsTo retrieve current camera settings, use the command:Syntax: gcp3.1 First Power Up Camera SettingsWhen the camera is powered up for the first time, it operates using the following factorysettings:PT-41-04M60• Flat field coefficients enabled (calibrated in exposure mode 2, 55 fps, and anexposure time of 2 ms [non-concurrent readout and integration], snapshot mode1, number of fast frame dumps = 1)• Exposure mode 2• 60 fps