8 Genie Monochrome Series Overview Genie Monochrome Series-GigE Vision CameraCamera Performance SpecificationsSpecifications for each available sensor are listed after the general Genie camera specifications.Camera ControlsSynchronization Modes Free running and TriggeredSynchronous and Reset modeSoftware trigger (through Ethernet)Exposure Modes Programmable (1μs granularity, minimum (see sensor data) – maximum 16s)Pulse controlledTrigger Input Opto-isolated, 2V to 12V typical, 2mA min.Debounce range from 1 μs up to 255 μsStrobe Output Output opto-isolated: Aligned to the start of exposure with a programmable delay,duration and polarityFeaturesLUT 8-bit / 10-bitFlip Real-time horizontal flipFlat Field Correction Real-time on cameraBinning Horizontal (2 pixel) and Vertical (2 line)Timestamp 1μs internal timer or external signal to timestamp images and eventsTest image Internal pattern generatorUser settings Select factory default or one user camera configurationOptical InterfaceBack Focal Distance—C-Mount 17.52 mmBack Focal Distance—CS-Mount 12.52 mmMechanical InterfaceCamera Size 29(H) x 44(W) x 67(L) in mm, ( see Mechanical Specifications )Mass < 125g (no lens)Power connector 12 pin male HiroseEthernet connector RJ45Electrical InterfaceInput Voltage CR-GENx-xxxxx models: +11 to +13 Volts DC at 0.6 Amp minimum,CR-GM0x-xxxxx models: +11 to +25.2 Volts DC at 0.6 Amp minimum,(over voltage–reverse voltage protected)Power Dissipation < 4WOperating Temperature 0 to 45°C (at front plate)Relative Humidity 5% to 90% non-condensing (operating)Output Data Configuration Gigabit Ethernet (IEEE 802.3)Data and Control GigE Vision compliant at 1000 or 100 Mbps
