QuickCam User's Manual 1003-032-10187-04 DALSA corp.Under Acquisition Control:2. Click the Start button.The camera is now grabbing images in continuous mode.From here you can also select whether or not to allow bad and/or incompleteimages to be acquired by selecting the Bad image passthrough and IgnoreMissing Packets options.To switch between continuous mode and snapshot mode:1. Click the button to continuously grab imagesorClick the button to take a snap shot of the image.Stopping Image AcquisitionTo stop acquiring images:1. Open the Connection tab in the Camera Configuration Window.Under Device Actions:2. Click the Stop button.Toolbar equivalent:Rebooting a CameraTo reboot the camera:1. Open the Connection tab in the Camera Configuration Window.On the Connect/Detect tab:2. Click the Reset Camera button.Toolbar equivalent:2.4 Saving and Restoring Camera SettingsSaving Camera SettingsYou can save the current camera settings to the camera’s non-volatile memory,allowing you to use them again after a camera reboot.
