Danfoss VLT AQUA Drive Design Manual

Also see for vlt aqua: Instructions Design guide Instruction manual Operating instructions Design guide

Contents

Illustration 5.1: Mounting of bottom plate, E1 enclosure.The bottom plate of the E1 enclosure can be mounted from either in- or outside of the enclosure, allowing flexibility in the installation process, i.e. ifmounted from the bottom the glands and cables can be mounted before the frequency converter is placed on the pedestal.5.2.4. Connection to Mains and EarthingNB!The plug connector for power can be removed.1. Make sure the frequency converter is properly earthed. Connect to earth connection (terminal 95). Use screw from the accessory bag.2. Place plug connector 91, 92, 93 from the accessory bag onto the terminals labelled MAINS at the bottom of the frequency converter.3. Connect mains wires to the mains plug connector.The earth connection cable cross section must be at least 10 mm2 or 2 rated mains wires terminated separately according to EN 50178.The mains connection is fitted to the main switch if this is included.NB!Check that mains voltage corresponds to the mains voltage of the frequency converter name plate.IT MainsDo not connect 400 V frequency converters with RFI-filters to mains supplies with a voltage between phase and earth of more than440 V.For IT mains and delta earth (grounded leg), mains voltage may exceed 440 V between phase and earth.5. How to Install VLT® AQUA Drive Design Guide102 MG.20.N4.02 - VLT® is a registered Danfoss trademark5