3. Choose “Read from drive”4. Choose “Save as”All parameters are now stored in the PC.Load Drive Settings:1. Connect a PC to the unit via USB com port2. Open MCT 10 Set-up software3. Choose “Open”– stored files will be shown4. Open the appropriate file5. Choose “Write to drive”All parameter settings are now transferred to the drive.A separate manual for MCT 10 Set-up Software is available.The MCT 10 Set-up Software ModulesThe following modules are included in the software package:MCT 10 Set-up SoftwareSetting parametersCopy to and from frequency convertersDocumentation and print out of parameter settings incl. diagramsExt. User InterfacePreventive Maintenance ScheduleClock settingsTimed Action ProgrammingSmart Logic Controller Set-upCascade Control Config. ToolOrdering number:Please order your CD containing MCT 10 Set-up Software using code number 130B1000.MCT 10 can also be downloaded from the Danfoss Internet: WWW.DANFOSS.COM, Business Area: Motion Controls.MCT 31The MCT 31 harmonic calculation PC tool enables easy estimation of the harmonic distortion in a given application. Both the harmonic distortion of Danfossfrequency converters as well as non-Danfoss frequency converters with different additional harmonic reduction devices, such as Danfoss AHF filters and12-18-pulse rectifiers, can be calculated.Ordering number:Please order your CD containing the MCT 31 PC tool using code number 130B1031.MCT 31 can also be downloaded from the Danfoss Internet: WWW.DANFOSS.COM, Business Area: Motion Controls.5.7. Safety5.7.1. High Voltage TestCarry out a high voltage test by short-circuiting terminals U, V, W, L 1, L2 and L 3. Energize maximum 2.15 kV DC for 380-500V frequency converters and2.525 kV DC for 525-690V frequency converters for one second between this short-circuit and the chassis.NB!When running high voltage tests of the entire installation, interrupt the mains and motor connection if the leakage currents are toohigh.5. How to Install VLT® AQUA Drive Design Guide126 MG.20.N4.02 - VLT® is a registered Danfoss trademark5