Danfoss VLT AQUA Drive FC 202 Operating Instructions Manual

Also see for VLT AQUA Drive FC 202: Service guide Installation guide Installation guide Operating guide Installation guide

The SmartStart configures the frequency converter in 3phases, each consisting of several steps, see Table 5.6.Phase Comment1 Basic Programming Program e.g. motor data2 Application SectionSelect and programappropriate application:• Single pump/motor• Motor alternation• Basic cascade control• Master/follower3 Water and Pump Features Go to water and pumpdedicated parametersTable 5.6 SmartStart, Setup in 3 Phases5.4.2 Commissioning via [Main Menu]Recommended parameter settings are intended for start-up and checkout purposes. Application settings may vary.Enter data with power ON, but before operating thefrequency converter.1. Press [Main Menu] on the LCP.2. Press the navigation keys to scroll to parametergroup 0-** Operation/Display and press [OK].130BP066.101107 RPM0 - ** Operation/Display1 - ** Load/Motor2 - ** Brakes3 - ** Reference / Ramps3.84 A 1 (1)Main menuIllustration 5.2 Main Menu3. Press navigation keys to scroll to parametergroup 0-0* Basic Settings and press [OK].0-**Operation / Display0.0%0-0* Basic Settings0-1 * Set-up Operations0-2 * LCP Display0-3 * LCP Custom Readout0.00A 1(1)130BP087.10Illustration 5.3 Operation/Display4. Press navigation keys to scroll to 0-03 RegionalSettings and press [OK].0-0*Basic Settings0.0%0-03 Regional Settings[0] International0.00A 1(1)130BP088.10Illustration 5.4 Basic Settings5. Press navigation keys to select [0] International or[1] North America as appropriate and press [OK].(This changes the default settings for a numberof basic parameters).6. Press [Main Menu] on the LCP.7. Press the navigation keys to scroll to0-01 Language.8. Select language and press [OK].9. If a jumper wire is in place between controlterminals 12 and 27, leave 5-12 Terminal 27 DigitalInput at factory default. Otherwise, select NoOperation in 5-12 Terminal 27 Digital Input. Forfrequency converters with an optional bypass, nojumper wire is required between controlterminals 12 and 27.10. 3-02 Minimum Reference11. 3-03 Maximum Reference12. 3-41 Ramp 1 Ramp Up Time13. 3-42 Ramp 1 Ramp Down Time14. 3-13 Reference Site. Linked to Hand/Auto LocalRemote.5.4.3 Asynchronous Motor SetupEnter the motor data in parameter 1-20 Motor Power [kW]or 1-21 Motor Power [HP] to 1-25 Motor Nominal Speed. Theinformation can be found on the motor nameplate.1. 1-20 Motor Power [kW] or 1-21 Motor Power [HP]2. 1-22 Motor Voltage3. 1-23 Motor Frequency4. 1-24 Motor Current5. 1-25 Motor Nominal SpeedCommissioning VLT® AQUA Drive FC 202 Operating Instructions24 MG20MA02 - Rev. 2013-10-2955