Danfoss VLT AutomationDrive FC 360 Programming Manual

Also see for VLT AutomationDrive FC 360: Quick guide Quick guide Quick guide Programming guide Design guide

Contents

Danfoss VLT AutomationDrive FC 360 Programming Manual Manual pdf 78 page image

3.13 Parameters: 16-** Data Read-outs16-00 Control WordRange: Function:0 * [0 - 65535 ] View the Control word sent from thefrequency converter via the serial communi-cation port in hex code.16-01 Reference [Unit]Range: Function:0 ReferenceFeed-backUnit*[-4999 - 4999ReferenceFeed-backUnit]View the presentreference value appliedon impulse or analogbasis in the unitresulting from theconfiguration selectedin 1-00 ConfigurationMode.16-02 Reference [%]Range: Function:0 %* [-200 - 200%]View the total reference. The totalreference is the sum of digital, analog,preset, bus, and freeze references, pluscatch-up and slow-down.16-03 Status WordRange: Function:0 * [0 - 65535 ] View the Status word sent from the frequencyconverter via the serial communication port inhex code.16-05 Main Actual Value [%]Range: Function:0 %* [-200 - 200 %] View the 2-byte word sent with the statusword to the mus master rporting themain actual value.16-09 Custom ReadoutRange: Function:0 CustomRea-doutUnit*[0 - 9999 Custom-ReadoutUnit]View the custom read-out from 0-30 CustomReadout Unit to0-32 Custom ReadoutMax Value.3.13.1 16-1* Motor Status16-10 Power [kW]Range: Function:0 kW* [0 -1000 kW]Displays motor power in kW. The value shownis calculated on the basis of the actual motorvoltage and motor current. The value isfiltered, and therefore approx. 30 ms may passfrom when an input value changes to whenthe data read-out values change. Theresolution of read-out value on fieldbus is in10 W steps.16-11 Power [hp]Range: Function:0 hp* [0 - 1000hp]View the motor power in HP. The value shownis calculated on the basis of the actual motorvoltage and motor current. The value isfiltered, and therefore approximately 30 msmay pass from when an input value changesto when the data read-out values change.16-12 Motor VoltageRange: Function:0 V* [0 - 65535 V] View the motor voltage, a calculated valueis used for controlling the motor.16-13 FrequencyRange: Function:0 Hz* [0 - 6553.5 Hz] View the motor frequency,withoutresonance dampening.16-14 Motor currentRange: Function:0 A* [0 - 655.35A]View the motor current measured as a meanvalue, IRMS. The value is filtered, and thusapproximately 30 ms may pass from whenan input value changes to when the dataread-out values change.16-15 Frequency [%]Range: Function:0 %* [0 - 6553.5 %] View a two-byte word reporting the actualmotor frequency (without resonancedampening) as a percentage (scale0000-4000 Hex) of 4-19 Max OutputFrequency.Parameter Descriptions VLT® AutomationDrive FC 360 Programming Guide76 MG06C102 - VLT® is a registered Danfoss trademark33