Danfoss VLT AutomationDrive FC 360 Quick Manual

Also see for VLT AutomationDrive FC 360: Quick guide Quick guide Quick guide Programming guide Programming guide

Danfoss VLT AutomationDrive FC 360 Quick Manual Manual pdf 27 page image

5.1.4 The Right-key Function on LCP 21Press [►] to edit any of the 4 digits on the displayindividually. When pressing [►] once, the cursor moves tothe first digit and the digit starts flashing as shown inIllustration 5.5. Press the [▲] [▼] to change the value.Pressing [►] does not change the value of the digits ormove the decimal point.130BC440.10Setup 1Setup 1Setup 1Setup 1Setup 1Illustration 5.5 Right-key Function[►] can also be used for moving between parametergroups. When in main menu, press [►] to move to the firstparameter in the next parameter group (e.g. move from0-03 Regional Settings [0] International to 1-00 ConfigurationMode [0] Open loop).5.2 Main MenuThe main menu gives access to all parameters.1. To enter the main menu, press [Menu] untilindicator in display is placed above main menu.2. [▲] [▼]: Browse through the parameter groups.3. Press [OK] to select a parameter group.4. [▲] [▼]: Browse through the parameters in thespecific group.5. Press [OK] to select the parameter.6. [►] and [▲] [▼]: Set/change the parameter value.7. Press [OK] to accept the value.8. To exit, press either [Back] twice (or 3 times forarray parameters) to enter main menu, or press[Menu] once to enter status.See Illustration 5.6, Illustration 5.7, and Illustration 5.8 for theprinciples of changing the value of continuous,enumerated and array parameters respectively. The actionsin the illustrations are described in Table 5.4, Table 5.5, andTable 5.6.130BC446.10Setup 1Setup 1Setup 1Setup 1Setup 1Setup 1Setup 1Setup 11234567101112OKOKBack8BackSetup 12 x+ OK9OKIllustration 5.6 Main Menu Interactions - ContinuousParametersLocal Control Panel and Pro... Quick GuideMG06A502 Danfoss A/S © Rev. 06/2014 All rights reserved. 255 5