Danfoss VLT ISD 410 Operating Instructions Manual

Contents

Danfoss VLT ISD 410 Operating Instructions Manual Manual pdf 6 page image

1 General Information1.1 Important Safety WarningsWARNINGHIGH VOLTAGEISD 410 servomotors operate at a high voltage whenconnected to the electrical supply network. A hazardousvoltage is present on the servomotors whenever they areconnected to the mains network via the power supplymodule and the connection box. There are no indicatorson the servomotor that indicate the presence of mainsvoltage. This indication is provided on the connection box.Installation, commissioning and maintenance may only beperformed by qualified staff. Incorrect installation, commis-sioning or maintenance can lead to death or serious injury.WARNINGUNINTENDED STARTA servomotor that is connected to the electrical supplynetwork can start running at any time. This may be causedby an external switch, a CAN bus command, a referencesignal, or clearing a fault condition. Servomotors and allconnected devices must be in good operating condition. Adeficient operating condition may lead to death, seriousinjury, damage to equipment or other material damagewhen the device is connected to the electrical supplynetwork. Take suitable measures to prevent unintendedstarts.WARNINGDISCHARGE TIMEThe DC link capacitors of the servomotors remain chargedfor some time after the mains supply is switched off at thepower supply module.To avoid electrical shock, fully disconnect the powersupply module from the mains before carrying outmaintenance. The DC links of the individual ISDservomotors are connected in parallel when they areconnected as a group, which increases the discharge time.Wait for at least the time listed below before carrying outmaintenance work:Number Minimum waiting time(discharge time)1-60 servomotors 10 minutesNote: High voltage may be present even if the LED on the ISDconnection box is not lit!Table 1.1 Discharge Time1.2 CopyrightDisclosure, duplication and sale of this document, as wellas communication of its content, are prohibited unlessexplicitly permitted. Infringement of this prohibition incursliability for damages. All rights reserved with regard topatents, utility patents and registered designs.ISD is a registered trademark.1.3 DisclaimerNo liability is assumed for any damage or breakdownresulting from:• Failure to observe the information in theinstruction manual• Unauthorised modifications to the ISD 410servomotors• Operator error• Improper work on or with the ISD 410servomotors.1.4 ApprovalsIllustration 1.11.5 Service and SupportContact your local service representative for service andsupport:http://www.danfoss.com/Contact/Worldwide/General Information VLT® ISD 410 Servomotor Operating InstructionsMG75D102 - VLT® is a registered Danfoss trademark 51 1