Danfoss VLT Series Programming Manual

Also see for VLT series: Service manual Installation guide Operating instructions Operating instructions Service manual

Contents

Danfoss VLT Series Programming Manual Manual pdf 97 page image

3.12 Main Menu - LonWorks - Group 11Parameter group for all LonWorks specific parameters.Parameters related to LonWorks ID.11-00 Neuron IDRange: Function:0 * [0 - 0 ] View the Neuron chip's unique Neuron ID number.11-10 Drive ProfileOption: Function:This parameter allows selecting betweenLONMARK Functional Profiles.[0] * VSD profile The Danfoss Profile and the Node Objectare common for all profiles.[1] Pump controller11-15 LON Warning WordRange: Function:0 * [0 - 65535 ] This parameter contains the LON specificwarnings.Bit Status0 Internal fault1 Internal fault2 Internal fault3 Internal fault4 Internal fault5 Reserved6 Reserved7 Reserved8 Reserved9 Changeable types10 Initialization error11 Internal communication error12 Software revision mismatch13 Bus not active14 Option not present15 LON input (nvi/nci) exceeds limits11-17 XIF RevisionRange: Function:0 * [0 - 0 ] This parameter contains the version of the externalinterface file on the Neuron C chip on the LONoption.11-18 LonWorks RevisionRange: Function:0 * [0 - 0 ] This parameter contains the software version of theapplication program on the Neuron C chip on theLON option.11-21 Store Data ValuesOption: Function:This parameter is used to activate storing ofdata in non-volatile memory.[0] * Off Store function is inactive.[2] Store allsetupsStores all parameter values in the E2PROM.The value returns to Off when all parametervalues have been stored.Parameter Description VLT® HVAC Drive Programming Guide96 MG.11.CC.02 - VLT® is a registered Danfoss trademark33