A. Using ModulesA-10 UniSite-xpi User ManualOpening/Removing aMatchBook To open a MatchBook, unsnap the retaining latch. To remove aMatchBook, open the MatchBook and lift it out of PinSite.Installing a PLCC orLCC Device in aMatchBook Use the following procedure to insert a PLCC or LCC device into aMatchBook after the appropriate Base has been installed in PinSite.1. Select and insert the appropriate MatchBook into the PLCC/LCCBase. For example, select the 44-pin PLCC MatchBook for a 44-pinPLCC device.2. Position the PLCC or LCC device so that pin 1 is at the center bottomas you view it from the top. Figure A-9 illustrates the properpositioning of a PLCC or LCC device.3. Insert the PLCC or LCC device into the open MatchBook. Make surethat the center bottom locating dot on the device is properly alignedwith the locating dot on the MatchBook.Note: Position the device so that pin 1 is near to the retaining clip. There is asmall dot molded into each MatchBook to help you align your device. EachPLCC MatchBook also has a beveled corner to help you align devices witha chamfered corner to indicate pin 1.4. Close the MatchBook and press the retaining latch forward with yourthumb until the latch snaps into place.Figure A-9Inserting a Device into the PLCCor LCC Base0538-3CHAMFEREDCORNERPIN 1
