2. Setup and InstallationUniSite-xpi User Manual 2-33Inserting a PLCC orLCC Device into aMatchBook Use the following procedure to insert a PLCC or LCC device into aMatchBook.1. Select the appropriate MatchBook and Base. For example, if you areusing a 44-pin PLCC device, you would select the 44-pin PLCCMatchBook and the PLCC Base.2. Insert the appropriate Base into the programmer.3. Insert the appropriate MatchBook into the Base.4. Position the PLCC or LCC device so that pin 1 is near the handle onthe Base. There is a small dot molded into each MatchBook to helpyou align your device. Each PLCC MatchBook and LCC MatchBookalso has a beveled corner to help you align devices with a chamferedcorner to indicate pin 1. Figure 2-13 illustrates the proper positioningof a PLCC or LCC device.5. Insert the device into the open MatchBook.6. Finally, close the MatchBook and press the retaining latch forwardwith your thumb until the latch snaps into place, as shown inFigure 2-12.CAUTION: Do not place excessive force on the top of the MatchBook, asthis may cause premature wear on the conductive pad.Figure 2-13Inserting a Device into the PLCCor LCC Base0538-3CHAMFEREDCORNERPIN 1
