34 SR200 & SR300 Printer and LM200 & LM300 Laminator User GuidePrinter Setting tabThe Printer Setting tab shows:• Controls for viewing or changing print settings:— YMC Ink Print Level, which sets the printdensity for color printing. Choose fromseven gradations from -3 (lighter) to +3(darker).— Resin K Ink Print Level, which sets the Kresin ink print density.Choose from sevengradations from -3 (lighter) to +3 (darker).— UV Ink Print Level. Choose from sevengradations from -3 (lighter) to +3 (darker).— Peel Off Ink Print Level. Choose from sevengradations from -3 (lighter) to +3 (darker).— Resin K Ink Print Mode which sets the K resin ink print quality. If Fine isselected, the print quality improves but the printing speed is slower. Changeto Fine if thin lines or small black text is blurred (printing speed is slower).— MG Peel Mode which sets the printer to use peel off ribbon in the magneticstripe area (if installed).— Standby Mode which pauses the card after printing and before transferringthe card to the laminator.— Back Side Cooling which pauses the card to cool it when printing on both sidesof the card.• Controls for viewing or changing magnetic stripe settings.Heating Yellow The printer is adjusting the heat roller temperature.Card LoadingCard TransportingContact IC EncodingNon-Contact ICEncodingMG EncodingPrintingRetransferYellow The printer is issuing cards. The operating status duringcard issuing is indicated. When the card is issued, theprinter goes into Ready state.Power Saving Yellow The printer is in power save mode. To end PowerSaving, press the Reset key on the printer and thenpress the Enter key to initialize the printer.Error Red See “Status monitor messages” on page 41 .
