16 Using the Printer and LaminatorLoading Retransfer Film1. Slide the door latch up and open the printer door (1).2. Press the retransfer film release button and remove thegreen cartridge (2).3. Remove both used film spools from the cartridge (ifpresent).4. Load the new roll of retransfer film on the cartridge:a. Put the full roll of film on the green supply spindle(A).b. Put the empty take‐up spool on the black take‐upspindle (B).c. Align film along the three film guides.d. Wind two frames of film onto the take‐up spool(D). Set the film so that a black frame line ispositioned next to the film guide, as shown on the label inside the cartridge.e. Take up any slack by turning the take‐up knobclockwise. Gently pull the take‐up knob and turn.If slack cannot be removed, verify that the supplyand take‐up spools are firmly seated on thespindles.To ease inserting into the printer, the film mustbe tight along the film guides. Turning the supplyand take‐up knobs helps maintain the propertension.5. Replace the loaded film cartridge in the printer until itclicks into position (5).6. Close the printer door (6).The retransfer film cartridge cannot be loaded if theprinter is in transport mode. Power on the printeruntil it displays an error, and then power it off againto cancel transport mode, if necessary.12E65
