REFERENCES 55.5.2 Enter Sleep TimeoutFor readers that have the Sleep state enabled, this timeout determines when thereader will enter this state.5.5.3 StandbyIf this command is enabled, part of the CCD circuitry shuts down (Standby), in orderpower consumption when not reading. When the trigger is pressedis circuitry powers up. This mode causes a minor delay of about 100 ms before thereader is ready.For M-Series readers, standby is always enabled and is not configurable. To exitStandby press the trigger.5.6 READING PARAMETERS5.6.1 Operating ModeThis group of parameters allows setting different reading modes for either Hand-Heldoperation or Stand operation:• Software Trigger: the reader is set in FLASH MODE. Code reading takes placeduring the flash on time;• Hardware Trigger: the code reading is started with a trigger press (ON);• Hardware Trigger Ready: the illuminator is switched ON when the reader sees acode. It functions as a pointer aiming at the code to be read. The reading phasestarts only w is automaticallyset to trigger active level and one read per cycle parameters. (Only for Hand-Held operation);• Automatic: the illuminator is switched ON when the reader sees a code. Thereading phase starts automatically;• Always ON: the illuminator is always ON and the reader always ready for codereading. This value is not available for M-Series readersto optimize lowthhen the trigger is pressed. In this mode the reader.139
