Setup10 Gryphon™ I GD/GBT/GM4500Connect Host InterfaceThe scanner kit you ordered to match your interface should provide a compati-ble cable for your installation. If this is not so, contact Technical Support.The scanner can communicate using the interfaces illustrated below.For corded versions, connect the reader cable by inserting the cable into thehandle as shown in the following Figure. To remove it, insert a paper clip intothe release aperture, then unplug the cable.Figure 3Cable ConnectorPaper clip. Cable Connection/Disconnection at the ScannerRS-232 Serial ConnectionTurn off power to the terminal/PC and connect the scanner to the terminal/PCserial port via the RS-232 cable as shown in Figure 4. If the terminal will notsupport POT (Power Off the Terminal) to supply scanner power, use theapproved power supply (AC Adapter). Plug the AC Adapter barrel connector intothe socket on the RS-232 cable connector and the AC Adapter plug into a stan-dard power outlet.RS-232: The scanner can communicate with a standard or Wincor-Nixdorf (W-N)RS-232 host.RS-232 OPOS: This interface is used for OPOS/UPOS/JavaPOS systems.Keyboard Wedge ConnectionThe Keyboard Wedge cable has a ‘Y’ connection from the scanner. Connect thefemale to the male end from the keyboard and the remaining end at the key-board port at the terminal/PC.Keyboard Wedge (KBW) : When connected using this interface, the host interpretsscanned data as keystrokes and supports several international keyboards (forthe Windows® environment). See "Country Mode" on page 56 for a full listing.USB ConnectionConnect the scanner to a USB port on the terminal/PC using the correct USBcable for the interface type you ordered.USB : Select to communicate either by USB OEM, USB COM STD, or USB Keyboardinterface types by scanning the appropriate interface type bar codes available inthis manual. The default interface is USB-KBD, or RS-232-STD.
