RF FeaturesProduct Reference Guide 299RF FeaturesAutomatic Configuration UpdateWhen this feature is enabled, the base station and reader will keep their config-urations synchronized. If a reader's configuration is altered by reading pro-gramming labels, this change is automatically transferred and updated in alinked base station. Likewise, if the base station's configuration is changedusing Aladdin or by host commands, then the reader's configuration will auto-matically be updated if this feature is enabled.RF Address StampingSource Radio Address Delimiter CharacterThis option specifies the delimiter character to be placed between the labeldata and radio address when address stamping is enabled.NOTEThis feature only applies if "Source Radio Address Transmission" onpage 249 is enabled.Follow these instructions to select the delimiter character:1. Determine the desired character, then find its hexadecimal equivalent onthe ASCII Chart on the inside back cover. A setting of 00 specifies no delim-iter character.2. Go to page 250 and scan the ENTER/EXIT PROGRAMMING MODE bar codeto enter Programming Mode.3. Scan the bar code: SET SOURCE RADIO ADDRESS DELIMITER CHARACTER.4. Scan the appropriate two digits from the keypad in Appendix D, Keypad,that represent the hexadecimal characters which were determined in thesteps above. You will hear a two-beep indication after the last character.NOTEIf you make a mistake before the last character, scan the CANCEL bar codeto abort and not save the entry string. You can then start again at thebeginning.5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.Table 22. Source Radio Address Delimiter Character Setting ExamplesSTEP ACTION EXAMPLES1 Desired Setting No delimitercharacter , (comma) - (dash) / (slash)2 Scan ENTER/EXIT PROGRAMMING MODE3 Scan SET SOURCE RADIO ADDRESS DELIMiTER CHARACTER4 Scan Two Characters FromAppendix D, Keypad ‘0’ and ‘0’ ‘2’ and ‘C’ ‘2’ and ‘D’ ‘2’ AND ‘F’5 Scan ENTER/EXIT PROGRAMMING MODE
