References302 Gryphon™ I GD/GBT/GM4500SymbologiesSet LengthLength Control allows you to select either variable length decoding or fixedlength decoding for the specified symbology.Variable Length: For variable length decoding, a minimum and maximum lengthmay be set.Fixed Length: For fixed length decoding, two different lengths may be set.Set Length 1This feature specifies one of the bar code lengths for a given symbology.Length 1 is the minimum label length if in Variable Length Mode, or the firstfixed length if in Fixed Length Mode.Reference the 1D Symbologies on page 113 section to view the selectable range(number of characters) for the symbology being set.Follow these instructions to set this feature:1. Determine the desired character length. Pad the number with leadingzeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.2. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-ming Mode.3. Scan the “Select Length 1 Setting” for the symbology being set.4. Scan the appropriate two digits from the keypad in Appendix D, Keypad, thatrepresent the length setting which was determined in the steps above. Youwill hear a two-beep indication after the last character.NOTEIf you make a mistake before the last character, scan the CANCEL barcode to abort and not save the entry string. You can then start againat the beginning.5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit ProgrammingMode.This completes the procedure. See the table below for examples of how to setthis feature.Table 25. Length 1 Setting ExamplesSTEP ACTION EXAMPLES1 Desired Setting 01 Character 07 Characters 52 Characters 74 Characters2 Scan ENTER/EXIT PROGRAMMING MODE3 Scan SELECT LENGTH 1SETTING for the desired symbology4 Scan Two Characters FromAppendix D, Keypad ‘0’ and ‘1’ ‘0’ and ‘7’ ‘5’ and ‘2’ ‘7’ AND ‘4’5 Scan ENTER/EXIT PROGRAMMING MODE
