Setup16 Heron™ HD3130Resetting the Product Configuration to DefaultsIf you aren't sure what programming options are in your scanner, or you'vechanged some options and want to restore the Custom Default Configurationthat may have been saved in the scanner, scan the Restore Custom Default Config-uration bar code below. This will restore the custom configuration for the cur-rently active interface.NOTE$P,HA00,PRestore Custom Default ConfigurationCustom defaults are based on the interface type. Configure the scanner forthe correct interface before scanning this label.If you aren't sure what programming options are in your scanner, or you'vechanged some options and want to restore the Factory Configuration, you havetwo options. You can scan the Restore USA Factory Configuration bar code or theRestore EU Factory Configuration bar code below. Both labels restore the scannerconfiguration to the factory settings including the interface type. The USA labelrestores Label IDs to those historically used in the USA. The EU label restoresLabel IDs to those historically used in Europe. The Label ID sets for USA and EUare shown in the Label ID section of this manual.CAUTIONRestore USA Factory Configuration$P,AE,PRestore EU Factory Configuration$P,Ae,PScanning either of the “Restore Factory Configuration” commands belowwill result in the loss of any custom configuration settings for your device.The programming section on the following pages lists the factory default set-tings for each of the menu commands (indicated by shaded blocks and boldtext).
