Product Reference Guide 6-57Global PrefixThis feature applies to RS-232 interfaces (Standard, Wincor-Nixdorf, andSingle Cable). It specifies the prefix that is added to beginning of labeltransmission.To specify the Global Prefix Character(s):1. Scan the SWITCH bar code.2. Scan the bar code, SET GLOBAL PREFIX below. You’ll need tocover any unused bar codes to ensure the scanner reads only thebar code you intend to scan.3. Scan the appropriate characters/digits from the keypad inAppendix C that represent the hex designation for the desiredcharacter(s). A table containing the ASCII Character Set and theircorresponding Hex Values is available in the inside back cover ofthis manual. ASCII parameters must be input by scanning a pairof hexadecimal digits for each character. Thus, to set a two-char-acter value of AB, bar codes containing the digits ‘4’, ‘1’, ‘4’, and‘2’ must be scanned. The selectable range for this option is anyhex value from 00 to FF. Up to 20 hex pairs can be designated.4. If designating the full 20 hex pairs, the scanner will automaticallyexit Programming Mode when the appropriate amount of digitshave been scanned. If designating less than 20 hex pairs, you canend the programming sequence early by scanning the TERMI-NATE SEQUENCE bar code.5. Complete the programming sequence by scanning the SWITCHbar code.NOTETo specify “no Global Prefix,” scan 00.
