3-6 Magellan® 8100/8100Ω and 8200/8200Ω Scanner• When the scanner or scanner/scale completes its Selftest success-fully, it emits a power-up tone (when configured to do so) andenters Operating Mode.Operating ModeOperating Mode includes Normal Operation (scanning and weighing)and Sleep Mode. These two modes are most commonly observed by theuser/operator.Normal OperationThis condition is indicated by the green light being on dim and steady.For scanner/scale models, the yellow light indicates that the scale senses aweight of zero on the platter. If you have a scanner without scale model,the yellow lamp will not be lit when the scanner is ready for scanning.Once the scanner enters Normal Operation, it begins a countdownsequence. If there is no activity during a preset period of time (also calledtimeout 1), the unit will shut off the laser and/or motor in order to prolongthe life of the electrical and mechanical components. Once the scanner hastimed out, it enters Sleep Mode.Sleep ModeAfter the scanner has been left idle for a preset period of time, the laserand/or motor automatically turns off (goes to sleep). This state is calledSleep Mode, and is indicated by a “slow” blink of the green light (blinkingat a 2-second rate). To wake up the unit, press anywhere on the weighplatter (scanner/scale models only), press the Volume Selection switch,press the trigger of an attached handheld scanner, or wave your hand infront of the vertical window. The unit will recognize any of these signals asa wake-up call and instantly return to Normal Operation.NOTEYellow and Green LED indications are configurable. Your scanner may not be pro-grammed to operate in the standard manner described above.1. “Timeout” and “Sleep Mode” time delays are programmable features that can be selected throughuse of the programming labels included in Section 6, Programming.
