6-164 Magellan® 8100/8100Ω and 8200/8200Ω ScannerGTIN Code 128 Supplemental Label IDThis feature specifies a GTIN label ID to be added to bar code data whenGTIN conversion is enabled and Code 128 supplemental addon bar codelabels are convertedTo set this feature:1. Scan the SWITCH bar code.2. Scan the bar code, SET GTIN CODE 128 SUPPLEMENTALLABEL ID below. You’ll need to cover any unused bar codes on thisand the facing page to ensure the scanner reads only the bar codeyou intend to scan.3. Scan the appropriate digits from the keypad in Appendix C that rep-resent the desired Label ID characters; entered as two hex pairs. Atable containing the ASCII Character Set and their correspondingHex Values is available in the inside back cover of this manual.ASCII parameters must be input by scanning a pair of hexadecimaldigits for each character. Thus, to set a two-character value of AB,bar codes containing the digits ‘4’, ‘1’, ‘4’, and ‘2’ must be scanned.The selectable range for this option is any hex value from 00 to FF(for each of the two characters).4. Complete the programming sequence by scanning the SWITCHbar code.SET GTIN CODE 128 SUPPLEMENTAL LABEL IDNOTEThe programming feature, RS-232 Label ID Control, designates whetherthe Label ID is transmitted as a prefix or suffix or if Label ID is disabled.
