Product Reference Guide F-1Appendix FProgramming ParametersOverviewThis section contains information about programmable settings for the Pegaso withWindows CE. Use the Falcon Management Utility (FMU), the Decoding ControlPanel applets, or the bar codes provided in Appendix G to program the Pegaso.Table F-2 starting on page F-3 provides the following information:• Code Parameter is the “human” name for the programming option.• I.D. # is the “decoder” name for the programming option. For example, to set aCode 39 minimum label length, use I.D. 0120. Programming I.D. numbers givenin this appendix can be used with all programming methods.• On/Off is a toggle. 1 turns the parameter on, and 0 turns it off.• Acceptable Input gives the settings or range of settings for each code parameter.• Defaults indicates how the parameter is set when the predefined default FF39,FF3A, or FF3B is selected.• Minimum (FF39) turns every on/off parameter off and sets all minimum andMaximum Label Lengths to the lowest values.• Maximum (FF3A) turns every on/off parameter on, sets all Minimum LabelLengths to the lowest values, and sets all Maximum Label Lengths to the highestvalues. Use this default for troubleshooting; it provides the best settings for read-ing an unknown bar code symbology and can identify the symbology of scannedbar codes.• Factory (FF3B) is the factory setting installed on the Pegaso. This default set willwork for most applications. To reset the Pegaso to the original defaults, scan theFactory bar code on page G-2.
