Datalogic PowerScan BT8300 Family Quick Reference Manual

Also see for PowerScan BT8300 Family: Guide Product reference guide

Datalogic PowerScan BT8300 Family Quick Reference Manual Manual pdf 12 page image

Connecting the PowerScan BT830010 PowerScan™ BT8300Before You BeginIn order to use the connection procedures below, the handheld and base stationmust be in an UNPAIRED state. If the reader is connected to a device, you mustfollow the procedure below to UNPAIR the Base Station and the handheld beforeattempting to link to a new device. If the handheld is not already connected toanother device, then you can skip this step and go straight to the Linkinginstructions that begin on the next page.Unpairing the ReaderTo unpair the PowerScan BT8300 reader from a BC 8030-BT base station, pressand hold the button on the BC 8030-BT (>8 seconds), then read the Unpair barcode below with each PowerScan BT8300 which you want to unpair from thecradle.You can Unpair the PowerScan BT8300 reader from a Bluetooth-Enabled PC tomake it available for pairing with another PC. Read the bar code above todisconnect the reader from its PCPlease note that in order to connect different scanners to a Base that is alreadyconnected to the maximum four scanners, you must follow the procedure above.Linking the PowerScan™ BT8300 to the BC 8030-BT CradleThe PowerScan BT 8300 reader can be connected with the PowerScan BC 8030-BT cradle in either of three ways.After the BC-8030-BT cradle is powered on and connected to the Host, configurethe Power Scan BT8300 by reading the following bar codes in the given sequenceas described in each section.UnpairRemember: The mandatory condition for establishing a newconnection between a BT reader and a BT cradle is that theyshare the same security configuration. The connection timeoutis 30 seconds. Four ascending beeps from the reader indicate asuccessful link, otherwise there are four descending tones.