RF Programming Manual 23WandEmulation Pre-/Post-NoiseSettingsThe number of noise transitions generated prior to or following labeltransitions are independently configurable options. To set noise transi-tions, enter Programming Mode by scanning the SET bar code, thenfollow these steps.1. Scan Don’t Transmit Pre-Noise or Don’t Transmit Post-Noise,followed by the END bar code to disable noise transitions, or...2. Scan the Set Pre- or Post-Noise Transitions bar code followedby the digits from Appendix C: Keypad that represent thedesired number of noise transitions. Select from one to twenty 1noise transitions for either pre- or post-noise. Complete theprogramming sequence by scanning the END bar code.Feature is specific to Base Station ONLY1. Scanners built prior to February of 2001 MUST select the digit one (1). See the note on this pagefor details.NOTESettings for this feature have been enhancedsince the product was originally released, add-ing the option to select a specific quantity ofnoise transitions. If your scanner was built priorto February of 2001, pre-noise/post-noise tran-sitions are enabled by following Step 2 above,EXCEPT the single digit selected from Appen-dix C: Keypad MUST be one (1). This will eitherset the pre-noise transitions to one or the post-noise transitions to three depending on whichfeature is being programmed. The feature is dis-abled in the same manner as Step 1 above.
