28 PowerScan® RF ScannerUsingMountingFlangesRefer to Figure 15a and follow these steps:1. Once you have identified the desired area for permanent BaseStation installation, hold the unit in place and mark the posi-tion of screws using the "mounting flanges."2. Start and remove four screws (provided) at the marked posi-tions in the mounting surface.3. Ensure that power and interface cables are securely connectedand routed in the channels provided in the bottom of the BaseStation.4. Secure the Base Station to the surface by installing the fourscrews into the mounting flanges. Base Station attachment isnow complete.Figure 15. Mounting Using Flanges or Two-sided TapeMountingUsing Two-Sided TapeYou can also affix the Base Station to a surface using the two-sided tapestrips provided with the unit. Simply remove the backing from oneside of the strips and apply them to the bottom of the Base Station asshown in Figure 15b. Remove the remaining backing from the tape,then position and firmly press the unit against a smooth, clean surfacein the orientation desired.Vertical (Wall)MountingThe Base Station can be mounted vertically using the same methods ashorizontal mounting (see previous section):1. Mounting Flanges (4) 3. Two-sided Tape Strips2. 4 Screws (provided) 4. BackingBASE IDTX/RXCHARGEPOWER1234a b
