Datalogic PowerScan RF User Manual

Also see for PowerScan RF: Programming guide

Contents

Datalogic PowerScan RF User Manual Manual pdf 38 page image

34 PowerScan® RF ScannerTheProgrammingSessionScanner programming allows you to customize the scanner’s configu-ration to match your specific needs. A typical programming session isconducted as follows:1. Scan the SET bar code at the top of the page. The scanner willemit one beep, indicating it has read the bar code and the greenLED will flash on and off slowly while the scanner remains inProgramming Mode. Normal scanning functions are disabled.2. Scan the programming bar codes(s) to make the desiredchanges. With few exceptions, the scanner will emit a triplebeep each time you scan a valid programming bar code..3. Scan the END label at the bottom of the page to save any newsettings and exit Programming Mode. The scanner will sounda beep and reset upon exiting Programming Mode, and thegreen LED will return to its usual state (on steady or off).The scanner will not exit Programming Mode unless the ENDbar code is scanned or the scanner’s battery is removed.Removing power during Programming Mode, before scanningthe END label, will cause all new settings to be ignored. Onpower-up, the scanner will return to previous settings.NOTENot all features are available for all interfaces. Thescanner will sound an error tone when scanningprogramming bar codes for features that cannot beused with the currently active interface. Only fea-tures supported by the currently active interfacewill be implemented.NOTEIf you are enabling a different interface (I/F), we sug-gest/recommend that you change the I/F designa-tion first and then proceed with other changes.Once a bar code is scanned that changes the scan-ner's I/F, all previous I/F configuration itemsscanned in the programming session are lost.