Datavideo DN-600 Instruction Manual

Also see for DN-600: Quick start guide

Datavideo DN-600 Instruction Manual Manual pdf 28 page image

28PULSE trigger Playback processUsing the Clip Status Display and soft keys select a pre-recorded video BIN. Make sure the outputdevice/monitor is connected and working with the recorder. Press in the Play button on the recorder’sfront panel. This should start the playback. The button on the connected GPI cabling is then pressedforcing the unit into play pause mode. The unit is then ready to playback from this point on the nextpress of the contact closure button. Press the stop button on the front panel of the recorder to endplayback of the video.LEVEL trigger Playback processUsing the Clip Status Display and navigation buttons select a pre-recorded video BIN. Make sure theoutput device/monitor is connected and working with the recorder. Press in the Play button on therecorder’s front panel. This should start the playback. The button on the connected GPI cabling isthen pressed forcing the unit into play pause mode for the length of the press. However, when thebutton is released the playback starts again. Press the stop button on the front panel of the recorderto end playback of the video.The contact closure button may be working in the opposite way to the type of action you want toperform. A mechanical change to the GPI contact closure trigger should fix this. ( Example: Whenpressed down the circuit is broken and recording starts. When released the contact is made causingthe pause action. )