8Front Panel DN-600Power light indicatorPower light on the DN-600 front panel is only used to confirm if the unitis powered ON or OFF. The Power ON/OFF switch is located on therear of the unit.LCD DisplayThere are four lines in the LCD Display. The first line is used to displayicons that reflect some of the current settings of the unit. These settingsinclude: ANA / DIG (Video Source is Analogue / Digital) HDV(Unit is set for HDV mode) Loop Play enabled Time RemainingThe second line will display the recording file type set for the selectedbin (eg. .MOV). While playing or recording it also displays the currentclip number and the total number of clips in the bin.The third line will display the bin number (01-99) and a time number(Hr:Min:Sec:Frame). The time number will represent the absolute timeaddress or the time code of the frame being recorded or played. Whenselecting a new bin, the time number will be the length of the content inthis bin. The fourth line labels the soft keys.Menu Navigation Left / Right soft keyThe functions of the two Soft Keys found below the LCD are dependentupon the current operation mode. Each function changes with eachdifferent operation mode. The Soft Key's current functions aredisplayed on the bottom line of the LCD panel, directly above eachrespective left / right Soft Key.Menu Navigation Menu keyUse this button to start navigating as well as exiting the various optionsoffered by DN-600. The functions are called out in the bottom two rowsof the LCD. Stepping through options is done by following thedirections set in the LCD annotations. At any time, an option can beexited by pressing this key.Note: Main menu selection can be accessed from a Stop or Idle mode.Specialized menu selections are accessed while playing.Fwd / Rew ButtonsIn playback mode these buttons will operate as Fast Forward andRewind Buttons. If the Menu Button is pressed these buttons willnavigate backwards and forwards between the various menu options.