DeLonghi DTC 95 DF Instruction Manual

Also see for DTC 95 DF: Operating instructions

Contents

38The installation of the gas appliance to Natural Gas or LP Gas must be carried out by asuitably qualified and registered installer. Installers shall take due account of the provi-sions of the relevant British Standards Code of Practice, the Gas Safety Regulations andthe Building Standards (Scotland)(Consolidation) Regulations issued by the ScottishDevelopment Department.Installation to Natural GasInstallation to Natural Gas must conform to the Code of Practice, etc.The supply pressure for Natural Gas is 20 mbar.The installation must conform to the relevant British Standards.Installation to LP GasWhen operating on Butane gas a supply pressure of 28-30 mbar is required. Whenusing Propane gas a supply pressure of 37 mbar is required.The installation must conform to the relevant British Standards.Warning: Only a suitably qualified and registered installer, also with technical knowl-edge of electricity should install the appliance. He should observe the Regulations andCodes of Practice governing such installation of gas appliances.Note: It is recommended that the gas connection to the appliance is installed with aflexible connecting tube made to BS5386.Notes: Flexible hoses can be used where the sited ambient temperature of thehose does not exceed 70°C. These hoses must be manufactured inaccordance with BS669 part 1 and be of the correct construction for thetype of gas being used. Gas hoses designed for natural gas MUST NOT be used for supplying LPGgas (LPG gas hoses can be identified by a either a red band or stripe onthe rubber outer coating of the hose).The hose should not be crushed or trapped or be in contact with sharp orabrasive edges.Using a suitable leak detection fluid solution (e.g. Rocol) check each gas connectionone at a time by brushing the solution over the connection.The presence of bubbles will indicate a leak.If there is a leak, tighten the fitting and then recheck for leaks.IMPORTANT!Do not use a naked flame to test for leaks.Gas connection