19DISPLAYED MESSAGESDISPLAYED MESSAGE POSSIBLE CAUSE SOLUTIONFILL TANK Insufficient water in the tank. Fill the tank with water and/or insert itcorrectly, pushing it as far as it will go until itclicks into place (fig. 3).EMPTY GROUNDS CONTAINER The grounds container (A14) is full. Empty the grounds container and drip tray,clean and replace (fig. 23).Important: when removing the drip tray, thegrounds container MUST be emptied, even if itcontains few grounds.If this is not done, when you make the nextcoffees, the grounds container may fill upmore than expected and clog the machine.GROUND TOO FINE ADJUSTMILLThe grinding is too fine and the coffee isdelivered too slowly or not at all.The grinding is too fine and the coffee isdelivered too slowly or not at all.Repeat coffee delivery and turn the grindingadjustment dial (fig. 10) one click clockwisetowards “7” while the coffee mill is inoperation. If after making at least 2 coffeesdelivery is still too slow, repeat the correctionprocedure, turning the grinding adjustmentdial another click until delivery is correct(see the section: “Adjusting the coffee mill”on page 12). If the problem persists, makesure the water tank is fully inserted, press thebutton and deliver a little water fromthe spout.INSERT GROUNDS CONTAINER After cleaning, the grounds container has notbeen replaced.Remove the drip tray and insert the groundscontainer.ADD PRE-GROUND COFFEE With the pre-ground function selected,pre-ground coffee has not been poured intothe funnel.Place pre-ground coffee in the funnel ordeselect the “pre-ground” function (fig. 14).DESCALE The machine must be descaled. The descaling procedure described in thesection “Descaling” needs to be performed assoon as possible (page 16).LESS COFFEE Too much coffee has been used. Select a milder taste by pressing the dial(fig. 7) or reduce the quantity of pre-ground coffee.FILL BEANS CONTAINER The coffee beans have run out. Fill the beans container (fig. 11).The pre-ground coffee funnel is clogged. Empty the funnel with the help of a brush asdescribed in the section “Cleaning the pre-ground coffee funnel”.INSERT INFUSER ASSEMBLY The infuser has not been replaced aftercleaning.Insert the infuser as described in theparagraph “Cleaning the infuser”.