Dea 124RR Instructions And Warnings
           | |
R1 2 4 R ROperating instructions and warnings15Table 1 Terminal board connection8 USE INSTRUCTIONSPress on the “OK” key to check if all inputs have been properly connected.FCAPEDSTARTFCCFOTOSTOPSIC1-2 24 V a.c. 24 V a.c. transformer power supply input3-4 24 V Batt 24 V d.c. battery power supply input (Follow carefully polarity indications)5-6LC/SCAFree contact max. capacity 5 A : this contact can be used to control an open gatewarning light (P27=0) or a courtesy lamp (P27≠0)7-8 LAMPFlashing light output 24 V d.c. max 15W art. Lumy 24S The intermittent output does notdemand the use of a flashing light card.9 COM Common safety devices9-10 +24VAUX+24 V d.c. power supply output for controlled safety devices. To be used as powersupply of photocell transmitters (in all cases) and of safety devices when testing theselatter before each operation9-11+24VSIC+24 V d.c. power supply output for auxiliary circuits and uncontrolled safety devices Tobe used as power supply of any auxiliary devices, photocell receivers (in all cases), andof safety devices when testing these latter before each operation12-13 Motor output 24 V d.c. max 70W14 FCA N.C. input limit switch while opening. If unused, short circuit to terminal n° 2115 FCC N.C. input limit switch while closing. If unused, short circuit to terminal n° 2116 START N.O. open input. If activated, it opens or closes both motors. It can work in “reversal”mode (P25=0) or “step-by-step” mode (P25=1)17 PEDON N.O. pedestrian opening input. If activated, it opens the motor18 STOP N.C. stop input. If activated, it stops the movement of both motors during any opera-tion. If unused, short circuit to terminal n° 2119FOTOCN.C. Photocell input. In case of activation it reverses the movement only while closing(P26=0) or it reverses the movement while closing and stops while opening (P26=1).If unused, short circuit to the terminal n°2120SICN.C. leaf safety device input. In case of activation it reverses the movement (P18=0) orit stops it (P18=1). If unused, short circuit to the terminal n°2121 COM Common inputs22 Aerial ground input23 Aerial signal inputMAfter making all connections to the terminal board, remember to short-circuit, whenever needed, anyunused input (see “connection to the control board”) and power the card: on the display you will read fora few seconds “rES-” followed by the symbol “----” which stands for gate closed.8.1 Visualisation of inputs status |
Related manuals for Dea 124RR
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine