29Activity Camera SetupActivity detection is used to record more images to disk from cameras that haveactivity. The sensitivity of activity can be adjusted and areas can be masked offaccording to the scene type.DetectionSelect whether activity detection is on or off for the selected camera.SensitivityThere are 5 levels of sensitivity for activity detection.Select the sensitivity level which matches the camera’s placing. Cameras sitedoutdoors where there may be a lot of background movement, such as trees orrain, should be set to Outdoor high or Outdoor low sensitivity. Cameras sitedindoors where there is very little background movement should be set to Indoorhigh, Indoor low, or very low sensitivity.Activity gridAn 8 x 16 grid is used to mask areas where activity detection is enabled. Whenthe grid is displayed, use the cursor keys to move the cursor to the desiredlocation and press a camera key to toggle the block on (white dot) or off.Activity Camera Set-Up Detection Off OnSensitivity Outdoor high Outdoor low, very low, Indoor high, Indoor lowActivity grid SetupActivity test Walk testActivity testUse this option to test and tune the sensitivity and activity grid set up for eachcamera. When activity is detected on the camera a white dot is displayed. Pressthe mode or menu key to exit the test.Activity detection can perform the following:Action Menu pageClose / Open relay 2 Activity SetupAutomatically copy the activity to Zip® or Jaz® Activity SetupDisplay the activity camera on screen Activity SetupChange the record rate Record ScheduleRecord exclusively or interleave the activity cameras Record ScheduleClose individual relays Activity Setup