Dedicated Micros ©2009 SD AdvancedSerial PortsThis menu allows configuration of the unit’s Serial ports. Refer to ‘Installing the Unit’ forinstallation information.Serial Port These are the four serial ports available.Port Config The serial ports can be configured to specific uses.Select from:None Switches port offDebug Sets port for serial communicationsPPP Sets port for Point to Point ProtocolTelem Sets port for Telemetry purposesComm Sets port for Comms purposesEPOS Sets the serial port for connection to anEPOS (Electronic Point Of Sale) deviceInterface Type Choose the type of serial interface being used. Select fromRS232, RS485 or RS422.Baud/Parity/Data/Stop/Flow Control These options allow the Serial port communication settings tobe configured.Note: When a telemetry protocol is selected, these settings will default to pre-determined valuesand should not normally be altered.Protocol This is a drop down list of serial telemetry protocols supported bythe unit.Note: Refer to ‘Appendix E’ for a full list of supported telemetry protocols.
